You are here

Reverse Reverb

A true reverse reverb followed by a forward reverb with delay and feedback. Set [SIZE] and Feedback [FEEDBK] at minimum for a straightforward tempo-sync-able rush-up reverse reverb, use [SIZE] to dial in a second reverb for increased wetness, and add [FEEDBK] around the whole thing for other-worldly ambiance.

H9 Control View - Click (+) for more info

Reverse Reverb Algorithm Controls
Mix [MIX]
wet/dry mixer, 100% is all wet signal
Decay [DECAY]
reverse decay in milliseconds or note-based in Tempo Mode (also the delay amount for [LATE])
Size [SIZE]
mixes in a standard reverb that is post reverse section for bigger sounds
Feedback [FEEDBK]
amount of delay feedback around reverse reverb (delay amount is DECAY amount)
Low Band Shelving Level [LO-LVL]
shelving boost/cut of low frequencies
High Band Shelving Level [HI-LVL]
shelving boost/cut of high frequencies
Late Dry Signal Level [LATE]
adjusts amount of dry signal that occurs directly after the reverse build up
Diffusion [DIFFUS]
diffusion in the reverse build-up: set to zero for a mechanical stutter
Modulation Level [MODLVL]
MicroPitch detuning modulation at the input
Contour [CONTUR]
increase the span between low and high crossover frequencies for the [LO-LVL] and [HI-LVL]. Affects the sound unless [LO-LVL] and [HI-LVL] are both set to 0.
Output Level
At 0 the output level is unaffected. Increase the output level of the effect by up to 20 dB or lower by 30 dB.
TEMPO ON / TEMPO OFF
Tempo is turned ON/OFF on the H9 by simultaneously pressing the Right Footswitch and the PRESETS button. With Tempo OFF, tapping can be used to adjust delay parameter values (displayed as milliseconds or Hz). With Tempo ON, tempo is in BPM.
Active
Turn effect on or off..
HotSwitch
The Middle Footswitch can be programmed to act on the loaded Preset as a programmable controller allowing the user to switch between the normal Preset parameter values and a programmed, alternate set of parameter values. It’s like having two Presets in one.
TAP
If Tempo is ON, the display indicates the current tempo in BPM (30 to 500 BPM) while tapping and the Tap LED will blink at the BPM rate. If Tempo is OFF, the display indicates the parameter value (milliseconds for most algorithms).