amp overdriving pedal!

Home › Forums › Products › Stompboxes › amp overdriving pedal!

  • This topic is empty.
Viewing 1 reply thread
  • Author
    Posts
    • March 27, 2008 at 4:45 pm #105502
      floyd01
      Participant

      When i use my timefactor in my fx loop on my amp(genz benz black pearl 30)It overdrives? the timefactor. And yes i have it set to line level on both the in and out. The loop is a serial line level loop. If i turn up the pre amp more than 1/4 way to get natural overdrive it clips the pedal. and it does not sound so good! Is this pedal true line level? I payed alot for this?pedal and and i just can't get it to work. I don't wan't to run this pedal in front of the amp, delay before gain sounds like crap to me. any insight would be helpfull?.thanx

    • March 27, 2008 at 5:11 pm #117246
      IDeangelis
      Member

       Floyd

      you are right about the fact Timefactor should be used in an FX loop if you want to use the amp distortion. 

      There are a few factors to consider:

      -the Eventide pedals are true Line Level devices.

      -make sure you know which type of level your fx loop uses (-20/-10dB or +4dB)

      -amps may use different level controls to feed the FX loop. Most use the Master output as Send control. Others have a dedicated SEND knob, mostly on the rear panel, close to the loop. Some may use the preamp gain. You need to understand how your amp works in this regards and use levels accordingly. Not all fx loops are created in the same way and some are also poorly designed.

      all the best

      I 

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.