I did the update – went smoothly. Cleared setup as recommended. Reconfiged Setup manually. Put back in my memory card that I've been using fine for 2 years. For some reason even though it says 'updating program files' I have none of my saved programs. Nothing exists in the 500 bank. I did nothing other then swap cards with my update card.
Tried putting the mem card on computer – and re copied my backup up folder that I saved on there back to it it and tried again – nothing. (I had backed it up by copying the contents of the mem card to a folder on my comp)
Any suggestions?
Also, getting freezes now bad too. As my main solo patch I use is Vintage DDL – I pulled up #189 – tweaked the FB a bit, set to 'Vintage' then every single time I try to modulate the Send button by holding it – the unit freezes. I assign a footpedal to Send to control my delay send live. So I'm kinda dead in the water here if I can't figure this one out. Any help would be accepted. Thanks.
