time factor display blinking “<-- TURN"

This topic is empty.

Viewing 2 reply threads

Author

Posts
- December 3, 2009 at 9:59 pm #106685
  
  taylor12k
  Participant
  
  in Looping mode, i can't get the TF to stop blinking "<– TURN".. no matter what i turn..
  
  how do i get this to stop!? thanks!
- December 3, 2009 at 10:07 pm #119591
  
  nickrose
  Moderator
  Eventide Staff
  
  In looper mode, when you have recorded a loop catchup mode is enabled on Dly Time A (Loop Start Point) and Dly Time B (Loop Length) and this is what you are seeing. One of these is probably sitting on the fence and causing the catchup display to be visible. If you wiggle both these knobs it should stop.
  
  If this doesn't fix it, it may be a bad contact on obe of these controls which would require service – contact your dealer or support@eventide.com in this case.
- December 3, 2009 at 10:18 pm #119592
  
  taylor12k
  Participant
  
  thanks, i'll wiggle those knobs some more..
  
  two other questions while i'm here:
  
  – my decay knob doesn't go lower than "2".. shouldn't it go to "0"?
  
  – also, my pitch increment can only be set to "octave".. as much as i turn the knob i can't select or see any of the other pitch intervals…
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.