“Cannot Connect” in Routing Utility

Home › Forums › Products › Rackmount › “Cannot Connect” in Routing Utility

  • This topic is empty.
Viewing 1 reply thread
  • Author
    Posts
    • October 20, 2010 at 12:44 pm #107334
      AndyScoresFilm
      Member

      I get the "cannot connect" message in the routing utility.  I'm de-selecting the checked "off-line" mode in order to connect. Sad

      I was originally able to connect without a hitch.  When I did, I created my own routing set up and saved it.  Since then, I loaded a different preset routing program in order to fix an issue with my blinking EXT light.  Now I want to go back to reload my saved program from the routing utility, but it won't allow me to go on line.

      Any solutions???

    • October 20, 2010 at 3:00 pm #120870
      nickrose
      Moderator
      Eventide Staff

      Hard to say without being there, or without more information. Things to check:

      1) Communication Setup, especially baud rate if serial.

      2) Cables

      3) Serial/MIDI settings on the H8000.

      4) Does the yellow busy light on the H8000 flash every few seconds ?

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.