Effect only on one side

This topic is empty.

Viewing 3 reply threads

Author

Posts
- May 8, 2011 at 4:17 am #107855
  
  wynsmth
  Member
  
  I just got a used Eclipse & I can only get the effected signal on one side & totally dry on the other. I am in a stereo in/stereo out effect loop of a Zentera combo amp. I can make the sides reverse by switching the cables & outputs so it's not the amp or the cables. Is this normal, is there some setting I am overlooking or do I have a defective unit? Thanks,
- May 9, 2011 at 3:13 pm #122068
  
  nickrose
  Moderator
  Eventide Staff
  
  If you've just got it, you would be well advised to return it to factory defaults (see UM). This will fix any inappropriate settings.
- May 9, 2011 at 8:16 pm #122071
  
  wynsmth
  Member
  
  Thanks, I tired that yesterday & it cleared things up but I would like to know where that setting is for future reference or was it just a glitch in the system. Thanks
- May 9, 2011 at 8:35 pm #133366
  
  nickrose
  Moderator
  Eventide Staff
  
  No glitches in this system !!
  
  Could have been one of two things that I can think of:
  
  1) Wet/dry set to 100% dry on one channel
  
  2) If V4.0 or later, could be output in mono mode (UM p.22)
Author

Posts

Viewing 3 reply threads

You must be logged in to reply to this topic.