Master Volume

This topic is empty.

Viewing 1 reply thread

Author

Posts
- September 8, 2011 at 4:15 pm #108098
  
  masch
  Member
  
  Hey there!
  
  This may sound like a stupid/rookie question but as much a I love the Eventide Time Factor I have touble setting a satisfatory level/volume for it to work along with my other pedals.No matter what I do the volume/level of the Time Factor seems to be considerably lower than the rest of the FX. I should mention that the Time Factor runs through an RG16 and is then controlled by a Ground Control unit. The other FX are a T REX chorus and reverb. When used on its own or in combination with the other two pedals the Time Factor isn't loud enough; Is there a master volume setting/knob that I should activate? Should I change one of the global or utility settings of the pedal?
  
  I'd be grateful for a clear answer, please forgive me in advance if the question sounds too noobish D
- September 12, 2011 at 9:39 pm #122646
  
  achaput
  Moderator
  
  New in Version 3 Software is
  
  Output Level Control
  
  TimeFactor now gives you the ability to individually adjust each Preset’s Output Level.
  
  In PLAY Mode, holding down the Left Footswitch for 2 seconds from
  Bypass state puts the unit into Active and also puts the unit into
  Preset O/P Level Adjust Mode. While the
  footswitch is pressed and
  held the display will show “OP 0dB” (default). While continuing to hold
  the footswitch down you can optionally turn the Encoder Knob to adjust
  Preset Output Level from –20dB to +6dB in 1dB increments. Preset must be
  saved to store this setting.e
  
  To adjust the Output Level in BANK Mode, press and hold the Left or Middle Footswitch while in Bypass.
  
  For info on updating software, visit this link.
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.