Pitchfactor midi out to modular synth?

Hello,

You may have to check that the setting for the MIDI OUT/THRU jack is set to OUT and not THRU…

Think you probably need to talk to Herr Doepfer – it's not really obvious what you are  trying to do.

Can't find a 190-2 on their Web Site, so, assuming that it is similar to an MSY2, it looks as though the MIDI clock from the PF would be translated into a SYNC clock signal. Note that PF has no reason to send MIDI start or stop signals.

Well, MIDI Channel selection wouldn't be an issue for MIDI Clock.   I hate to say this, but I see no MIDI Clock support listed for the A190-2 (either at this link, or found in the more in-depth manual).  Now, the A190(1) certainly seems to translate MIDI Clock into a 5V gate signal (link, and manual).  I hope that I'm missing something here, Alwaysnew.

You could test your connections by setting the PF to MIDI: CTRL XMT=ON.  Moving a knob after putting the A-190-2 into Learn mode should give you a variable voltage out of the CV4 jack.  Again, this will simply test if your PitchFactor is transmitting something, and your Doepfler module is receiving it.

… but it sure would be cool if the RESTART flex/function/footswitch in the HarPeggiator mode could XMT/RCV a Start message, Nick.   

I think that's going to be about it.   The knobs, an optional expression pedal, or an optional 3-way auxiliary switch set transmitting CCs, or a pitchbend message.    But that's only considering the routing and components that you've mentioned.  I can think of some possibilities with a MIDI event processor (to translate from one message to another), but that would still require a few more devices in the chain to make it useful.

If you have this particular Doepfer module, then it must be part of a larger modular system (at least an oscillator, filter, VCA).  Maybe it's a full-blown A-100.  With a module like the A190-2, I would run a sequencer (or even a cheap MIDI keyboard controller) through the PitchFactor, and then into your modular synthesizer [changing OUTPUT from XMT to THRU].

The value of such a routing would be in sending the MIDI notes, velocities, pitchbend, CC messages to the Doepfer system to use as gates, triggers, variable CV voltages, etc.  At the same time, the CC messages and pitchbend could be 'borrowed' by the PitchFactor for synchronized effects.

This would be especially effective if the audio output of the Doepfer system was processed by the PitchFactor.  But it's an equally valid routing to have another instrument processed by the PitchFactor, and have it 'bound together' with the A-100 system by virtue of similar, synchronized movement.

Don't get me wrong:  Life would be easier here with sync via MIDI Clock.  But I can still see good possibilities in combining these two devices (PF and Doepfer) together.