Using two amps with Time Factor

This topic is empty.

Viewing 2 reply threads

Author

Posts
- September 8, 2012 at 6:38 pm #109092
  
  Mauikihei
  Member
  
  I am using two amps with the pedal to maximize the stereo effect. Ois a Fender Deluxe and the other is a solid state Crate amp. The Deluxe works fine but the other amp does not seem to work well. The volume of the 2nd amp is always lower than it is when I plug directly into it. Is there some reason that the volume feed into the two amps is different? Can it be adjusted?
- September 10, 2012 at 10:08 pm #123813
  
  achaput
  Moderator
  
  Hello,
  
  Have you tried adjusting the Dly mix knob? This controls the balance between the two outputs.
- September 16, 2012 at 8:30 am #123833
  
  arcadesonfire
  Member
  
  Maybe check the switch on the back of the TF to make sure it's set to amp level for the output, rather than line level.
  
  If that's not the problem, then I'm wondering if you mean the whole level–including the dry–is lower out of the Crate than the Fender? If it's just the wet that's lower, then I'm guessing it's because the tube amp is compressing more than the crate? I use my TF through a Fender Hot Rod Deluxe set to sound clean and through a Marshall Plexi clone set to light overdrive. The delays compress (upwards) a lot more in the overdriven amp, so they sound louder.
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.