H9 out-of-phase issue in serial loop Boogie Mark IV

This topic is empty.

Viewing 2 reply threads

Author

Posts
- March 30, 2016 at 1:27 pm #113376
  
  7enderbender
  Member
  
  I ran into an odd issue in which if I turn on the effects loop of my Boogie Mark IV via a remote midi switcher the H9 seems to go out of phase when engaged (not when it is in hardware bypass mode). It goes away when I turn the effects loop on manually on the amp. So it may sound like an issue with the amp at first – however other effects pedals don’t show this behavior.
  
  The H9 is set to “normal” routing. Is that ok for use in a serial loop? Or what may I be missing? All levels seem to be ok.Thx
- March 30, 2016 at 2:01 pm #143049
  
  nickrose
  Moderator
  Eventide Staff
  
  The fact that this issue is affected by how you turn on the loop suggests that it is an issue with the amp.
  
  Note that pretty much all digital units may have have phase issues if mixed with a dry signal – this is because conversion and minimum processing will cause a delay of a few thousandths of a second, which can be noticeable. Analog pedals will not do this.
- March 31, 2016 at 6:28 am #143054
  
  Leon Todd
  Participant
  
  Have you turned “Killdry” on? Essential if you’re using the H9 in a parrallel fx loop (I’m doing this with my Dual Rec).
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.