Control an H9 with a Factor pedal’s knobs

Home › Forums › Products › Stompboxes › Control an H9 with a Factor pedal’s knobs

  • This topic is empty.
Viewing 3 reply threads
  • Author
    Posts
    • December 22, 2016 at 3:17 pm #113898
      shawnd
      Member

      I hear this is possible to do.  Basically control all the virtual knobs of the H9 with a ‘factor pedal’s physical knobs.   Is there a document or video on the setup of doing this?

       

       

       

       

      thank you

    • December 22, 2016 at 3:22 pm #145234
      nickrose
      Moderator
      Eventide Staff

      Essentially it is all in the User manuals.

      Look at:

      [XMT CC] to pick a MIDI CC for each knob (use the defaults)

       [CTL XMT] to enable this.

      [RCV CTL] to determine which knobs (same values as in XMT CC)

      [RCV CH] set this to OMNI

    • December 22, 2016 at 3:27 pm #145235
      shawnd
      Member

      What specific cable will be between the devices?

    • December 22, 2016 at 10:02 pm #145238
      nickrose
      Moderator
      Eventide Staff

      You want a regular MIDI cable, which is a 3 or 5 pin DIN cable, available on line or from an electronics shop (they are used for audio as well). Connect it from the Factor's MIDI OUT to the H9's MIDI IN. The plugs should look like one of the pictures below.

      DIN 41524: 3-pin, 90°, 180°DIN 41524 / IEC/DIN EN 60130-9: 5-pin, 45°, 180°

       

  • Author
    Posts
Viewing 3 reply threads
  • You must be logged in to reply to this topic.