Past: Owned the unit for about 5 years, always just tweaked presets, never really programmed. I had a checksum error in the past, did what the manual suggested (the “Fix” command), all fine.
Current: Was playing around and actually getting around to learning some programming! Saving patches in locations 1-7 and 10-12. Unit froze on patch 10. Turned off, held “Program” during the restart. Did this several times, finally worked again for about 10 seconds. Did the Program thing again, similar result. Decided to hold the “Setup” button during restart. Worked 10 seconds, froze again (always on patch 10, which did not actually get deleted). Did the Setup thing a few times, always worked just for seconds, then died. At one point, death meant gibberish on the screen, but usually it just freezes and buttons don’t do anything. Then, worked for about 3 minutes, then froze.
Any ideas?
