- Eventide Audio

Home › Forums › Products › Stompboxes › How to set In Lvl and Out Lvl for using Pre/Post routing on Factors? › Reply To: How to set In Lvl and Out Lvl for using Pre/Post routing on Factors?

December 22, 2017 at 5:58 pm #147964
Soham
Member

 

I have the same doubt. Because nobody has answered the question during these years?, The question seems very logical to me.

 

smalland wrote:

Hello,

 

The signal path :

   Guitar -> FACTOR Input 1 -> FACTOR Output 1 -> Amp -> Send -> FACTOR Input 2 -> FACTOR Output 2 -> Return

According to the manual, Output 1 is connected to the amp input, so In Lvl should be set to GUITAR and Out Lvl should be set to AMP(Pre routing).

But Output 2 goes to the amp return then In Lvl should be set to LINE Out Lvl should be set to LINE(Post routing).

In this case how can I properly set the Lvl toggles?

 

For now my solution is using two more pedals and set the two Lvl toggles to LINE :

  Guitar -> Pedal 1 -> FACTOR Input 1 -> FACTOR Output 1 -> Pedal 2 -> Amp -> Send -> FACTOR Input 2 -> FACTOR Output 2 -> Return

Is this a possible solution?

 

Thanks.

I have the same doubt. Because nobody has answered the question during these years?, The question seems very logical to me.