h90 latency on inserts

it’s like in the h90 is activated first the algos (so the clean guitar sound) and after the inserts (in my case the distortion pedal), with a noticeable latency.

the latency persist even with the algos in bypass mode

i have tested the same program with the algos in  bypass and the latency persist, than without algo in utility thru and it work pefectly with no latency(only insert2), in the end i have tested 1 algo in thru and the other algo with simple digital delay and the latency decreased, almost halved.

it is as if the algorithms have a latency weight in the activation.

p.s i used Upload Attachments for the program but i don’t if it works.

Latest h90 firmware software version, king of tone clone in the insert loop.

Tomorrow i will test it out of the switch looper and send you programs 👍

I think I understand the problem, basically when I activate the loop with the h90, for a fraction of a second the guitar sound passes from the program that is currently loaded on the eventide to then pass to the program recalled via midi by the looper. This is because the analog loop is faster than the “process” of changing programs on the h90.

In fact, this does not happen if instead of the algorithms I load only insert 2(or 1) and always recall via midi.

therefore the problem is the latency that is created in loading 2 algorithms and not in the transmission of the midi program change itself.

obviously if you use the buttons on the h90 this problem apparently doesn’t exist because I feel like the latency has been balanced, I don’t feel the immediacy of the preset change in the same speed as an analog looper to understand.

that’s why if instead of 2 algorithms I load only 1 I feel less latency, maybe just half

In summary, therefore, the slow midi communication does not seem to be the problem, perhaps the algorithm loading process should be optimised/speeded up.

.