H90 Aux Switch assignment issues

Home › Forums › Products › Stompboxes › H90 Aux Switch assignment issues

Viewing 2 reply threads
  • Author
    Posts
    • March 24, 2024 at 11:56 am #180019
      StrolloSound
      Participant

      Currently using 2 H90s each with their own Digitech FS3X 3 way footswitches as my “Aux Switches”

       

      One H90 is not allowing Performance Parameter Mapping of the Aux Switch.

      I am simply trying to map the Aux Switch to Active/Bypass for the on board switches 1,2,3

      I can only get the second (A) onboard switch to map to the foot switch

       

      Confirmed in I/O that Pedal 1 is set to switch 1-3

       

      The other H90 is allowing for each switch to be mapped normally

      Both are running software version 1.7.5.29

      swapped both cables an multiple foot switches same result

       

      Any suggestions?

    • March 24, 2024 at 12:11 pm #180020
      brock
      Participant

      All I can say initially is to try calibrating/re-calibrating the 3-Aux in the misbehaving H90.  That sounded like it might have been a TS cable issue, but you’ve already checked all of the potential combinations.

      I have a similar setup here. Let me see if I can come up with anything else that might be the cause.

    • March 24, 2024 at 2:54 pm #180021
      StrolloSound
      Participant

      Re calibration did it –

      I thought it was only for expression pedals

      Thank You!

  • Author
    Posts
Viewing 2 reply threads
  • You must be logged in to reply to this topic.