External control of Quickknob parameters

Thanks for the link, I’ll check that out. Does it cover both the onboard and midi controller version of the solution?

Regarding Overlay, do you have a screen shot or video that shows what it looks like?

From the video link I couldn’t see how, referring to the scenario, how you could map three different mix levels for the same algorithm to each of the performance switches. Am i missing something?

Are you saying that each of the performance switches P, A and B can all be used in the service of a single algorithm?

Hey thanks so much for your patience, I think i’ve got. I’ve successfully mapped different values of the same parameter to three different hot switches. However I’m now confused by the display of what I’m presuming is the Overlay.  Each of the switches are mapped to Hotswitch 1,2 and 3 but regardless of which one I press I get the same momentary message at the bottom of the screen: P/programme name/hotswtich on or off.  I was expecting the algorithm name with the parameter value or something similar.

H9 Control app confirms the value changes by the position of the parameter knob in the edited algorithm, A in this case but there is no such info on the device.

Hi ~ I’ve been trying to achieve the same results with midi. I’m not having much luck with mapping different values of the same parameter directly to different cc numbers. I can’t tell from the video if this is actually possible? Or do i have to do the Hotswitch mapping and then map the hotswitches to controller numbers?

Thanks for clarifying Overlay behaviour.

Re Scenario:

Naively I’d tried mapping three different mix positions for Algorithm A to three different cc numbers with a greater than 64 value. The thinking was this would reproduce the same outcome as mapping to three different hot switches.
It sounds like you’re suggesting the same CC number with different values would do the job. That would be very handy if I could work out how to do it.

Hey that’s great thanks! I had to clear some previous mapping experiments to get it working but got there. What’s also great is the CC values will do subdivisions of a selected parameter range.

With the MC60 P I can use the initial preset selection plus a long tap message and double tap message to get three mix settings with a single switch without having to leave the page or the bank.

Hi, thanks. Another question.  Is it possible to get a parameter sweep mapped to a Hot Switch? I’m thinking of the Mash button on the TC Flashback.

Yes I was thinking of something like a sweep through delay time values but doesn’t sound possible with a switch. I think the Mash switch was a pressure sensitive expression device. I remember a preset on the H9 with delay values preset for an expression pedal which was quite fun. It might have been lost lunch or something like that.

Next question then, Can an expression pedal be switched between mappings?  E.g. is it possible to switch an expression routing from say programme mix level to an algorithm delay tempo subdivisions. A longshot I know. Maybe a second expression pedal required.

Actually I’ve just watched a video which demonstrates switchable expression routing in the MC6 Pro.  It seems like having the expression pedal connected there instead of to the H90 might provide the answer.

Thanks broc, that’s useful and encouraging. Also good idea about two copies of a programme, hadn’t thought of that.